Netgear GS418TPP User Manual - Page 140

ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP The following table describes the nonconfigurable information displayed on the page. Table 33. VLAN status Field VLAN ID VLAN Name VLAN Type Routing Interface Member Ports Definition The VLAN identifier (VID) of the VLAN. The range of the VLAN ID is 1 to 4093. The name of the VLAN. VLAN ID 1 is always named Default. The VLAN type: • Default (VLAN ID = 1). Always present. • Static. A VLAN that you configured. • Dynamic. A VLAN created by GVRP registration that you did not convert to static, and that GVRP can therefore remove. The interface associated with the VLAN, in the case that VLAN routing is configured for this VLAN. The ports that are included in the VLAN. Configure Port PVID Settings You can assign a port VLAN ID (PVID) to an interface. The following requirements apply to a PVID: • You must define a PVID for all ports. • If no other value is specified, the default VLAN PVID is used. • To change the port's default PVID, you must first create a VLAN that includes the port as a member (see Configure VLAN Membership on page 137).  To configure PVID settings: 1. Connect your computer to the same network as the switch. You can use a WiFi or wired connection to connect your computer to the network, or connect directly to a switch that is off-network using an Ethernet cable. 2. Launch a web browser. 3. In the address field of your web browser, enter the IP address of the switch. Configure Switching 140