Netgear GS418TPP User Manual - Page 218

ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP This value controls the ICMPv6 error packets. The default rate limit is 100 packets per second, meaning that the burst interval is 1000 mseconds. To disable ICMP rate limiting, set this field to 0. The valid rate interval must be in the range 0 to 2147483647 mseconds. 9. In the ICMPv6 Rate Limit Burst Size field, specify the number of ICMP error packets allowed per burst interval. This value controls the ICMP error packets. The default burst size is 100 packets. When the burst interval is 0, then configuring this field is not a valid operation. The valid burst size is 1 to 200. 10. Click the Apply button. The updated configuration is sent to the switch. Configuration changes take effect immediately. View the IPv6 Route Table  To view the IPv6 Route Table: 1. Connect your computer to the same network as the switch. You can use a WiFi or wired connection to connect your computer to the network, or connect directly to a switch that is off-network using an Ethernet cable. 2. Launch a web browser. 3. In the address field of your web browser, enter the IP address of the switch. If you do not know the IP address of the switch, see Change the Default IP Address of the Switch on page 11. The login window opens. 4. Enter the switch's password in the Password field. The default password is password. The System Information page displays. 5. Select Routing> IPv6 > Basic > Route Table. 6. From the Routes Displayed menu, select one of the following options: • All Routes. Show all active IPv6 routes. • Best Routes Only. Show only the best active routes. • Configured Routes Only. Show only the manually configured routes. Configure Routing 218