Netgear GS418TPP User Manual - Page 195
Con MLD Snooping Querier, Switching > Multicast > MLD Snooping > Querier Configuration
View all Netgear GS418TPP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 195 highlights
ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP Configure MLD Snooping Querier You can configure the parameters for an MLD snooping querier. Only a user with read/write access privileges can change the settings on this page. To configure an MLD snooping querier: 1. Connect your computer to the same network as the switch. You can use a WiFi or wired connection to connect your computer to the network, or connect directly to a switch that is off-network using an Ethernet cable. 2. Launch a web browser. 3. In the address field of your web browser, enter the IP address of the switch. If you do not know the IP address of the switch, see Change the Default IP Address of the Switch on page 11. The login window opens. 4. Enter the switch's password in the Password field. The default password is password. The System Information page displays. 5. Select Switching> Multicast > MLD Snooping > Querier Configuration. 6. Configure the following settings: • Querier Admin Mode. Enable or disable MLD snooping for the switch. The default is Disable. • Querier Address. Enter an IP address. This specifies the snooping querier address to be used as the source address in periodic MLD queries. This address is used when no address is configured on the VLAN on which a query is being sent. The supported IPv6 formats are x:x:x:x:x:x:x:x and x::x. • MLD Version. Specify the MLD protocol version used in periodic MLD queries. • Query Interval(secs). Specify the interval in seconds between periodic queries sent by the snooping querier. The query interval must be a value in the range of 1 to 1800. The default value is 60. Configure Switching 195