Netgear GS418TPP User Manual - Page 399

ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP 5. Select Monitoring > Mirroring > Port Mirroring. 6. Select an Admin Mode radio button: • True. Port mirroring is enabled. • False. Port mirroring is enabled. 7. From the Destination Port menu, select the destination port to which port traffic must be copied. You can configure only one destination port on the system. The port functions as a probe port and receives traffic from all configured source ports. If no port is configured, None is displayed. The default is None. 8. Click the Apply button. The updated configuration is sent to the switch. Configuration changes take effect immediately. The following steps must be performed in the Source Interface Configuration section. 9. Use one of the following methods to narrow down the ports that are displayed: • Select Unit ID to display the physical ports of the selected unit. • Select LAG to display a list of LAGs only. • Select CPU to display a list of CPUs only. • Select All to display a list of all physical ports, LAGs, CPUs, and VLANs. 10. Use one of the following methods to select one or more source ports: • Select a specific interface by specifying the interface number using the respective naming convention (for example, g1 or l1) in the Go To Interface field and clicking the Go button. See Interface Naming Conventions on page 23 for more information. The entry corresponding to the specified interface is selected. • Select one or more check boxes in the Interface column. Traffic from the selected ports is sent to the probe port. 11. From the Direction menu, specify the direction of the traffic that must be mirrored from the selected source ports: • None. The value is not configured. This is the default setting. Monitor the System 399