Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 1006
show storm-control broadcast
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1006 highlights
www.dell.com | support.dell.com • Do not apply per-VLAN QoS on an interface that has storm control enabled (either on an interface or globally). • When broadcast storm control is enabled on an interface or globally on ingress, and DSCP marking for a DSCP value 1 is configured for the data traffic, the traffic will go to queue 1 instead of queue 0. • Similarly, if unicast storm control is enabled on an interface or globally on ingress, and DSCP marking for a DSCP value 2 is configured for the data traffic, the traffic will go to queue 2 instead of queue 0. Note: Bi-directional traffic (unknown unicast and broadcast), along with egress storm control, causes the configured traffic rates to be split between the involved ports. The percentage of traffic that each port receives after the split is not predictable. These ports can be in the same/different port pipes, or the same/different line cards. show storm-control broadcast c e s Display the storm control broadcast configuration. Syntax show storm-control broadcast [interface] Parameters interface (OPTIONAL) Enter one of the following interfaces to display the interface specific storm control configuration. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • Fast Ethernet is not supported. Defaults Command Modes Command History No default behavior or values EXEC EXEC Privilege Version 8.3.5.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.5.1.0 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Example Figure 40-1. show storm-control broadcast Command Example (E-Series) Force10#show storm-control broadcast gigabitethernet 11/11 Broadcast storm control configuration Interface Direction Percentage Wred Profile Gi 11/11 Ingress 5.6 Gi 11/11 Egress 5.6 - Force10# 1006 | Storm Control