Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 961
protocol-tunnel destination-mac, protocol-tunnel enable,
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 961 highlights
Command History Version 8.3.5.0 Version 8.2.1.0 Version 7.4.1.0 Introduced on S55 Introduced on the C-Series, E-Series and E-Series ExaScale. Introduced Example Figure 37-1. Protocol-tunneling Command Example Force10#conf Force10(conf)#interface vlan 2 Force10(conf-if-vl-2)#vlan-stack compatible Force10(conf-if-vl-2)#member Gi1/2-3 Force10(conf-if-vl-2)#protocol-tunnel stp Force10(conf-if-vl-2)# Usage Information Related Commands Note: When VLAN-Stacking is enabled, no protocol packets are tunneled. show protocol-tunnel Display tunneling information for all VLANs protocol-tunnel destination-mac c e s Overwrite the BPDU destination MAC address with a specific value. Syntax protocol-tunnel destination-mac xstp address Parameters stp Change the default destination MAC address used for L2PT to another value. Defaults The default destination MAC is 01:01:e8:00:00:00. Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.2.1.0 Version 7.4.1.0 Introduced on S55 Introduced on the C-Series and S-Series. Introduced Usage When VLAN-Stacking is enabled, no protocol packets are tunneled. Information Related Commands show protocol-tunnel Display tunneling information for all VLANs protocol-tunnel enable c e s Enable protocol tunneling globally on the system. Syntax protocol-tunnel enable To disable protocol tunneling, use the no protocol-tunnel enable command. Defaults Disabled Service Provider Bridging | 961