Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 87

Defaults See parameters above. Command Modes EXEC EXEC Privilege Command History Version 8.3.5.0 Version 8.3.1.0 Version 8.2.1.0 Version 8.1.1.0 Version 7.9.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 Introduced on the S55. Introduced extended ping options. Introduced on E-Series ExaScale (IPv6) Introduced on E-Series ExaScale (IPv4) Introduced VRF Introduced on S-Series Introduced support for C-Series Added support for IPv6 address on E-Series Usage Information When you enter the ping command without specifying an IP/IPv6 address (Extended Ping), you are prompted for a target IP/IPv6 address, a repeat count, a datagram size (up to 1500 bytes), a timeout in seconds, and for Extended Commands. See Appendix , for information on the ICMP message codes that return from a ping command. Figure 4-7. Command Example: ping (IPv4) Force10#ping 172.31.1.255 Type Ctrl-C to abort. Sending 5, 100-byte ICMP Echos to 172.31.1.255, timeout is 2 seconds: Reply to request 1 from 172.31.1.208 0 ms Reply to request 1 from 172.31.1.216 0 ms Reply to request 1 from 172.31.1.205 16 ms : : Reply to request 5 from 172.31.1.209 0 ms Reply to request 5 from 172.31.1.66 0 ms Reply to request 5 from 172.31.1.87 0 ms Force10# Figure 4-8. Command Example: ping (IPv6) Force10#ping 100::1 Type Ctrl-C to abort. Sending 5, 100-byte ICMP Echos to 100::1, timeout is 2 seconds: !!!!! Success rate is 100.0 percent (5/5), round-trip min/avg/max = 0/0/0 (ms) Force10# Control and Monitoring | 87