Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 651

Parameters interface all events packet brief detail tx rx both Enter the following keywords and slot/port or number information: • For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword gigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword tenGigabitEthernet followed by the slot/port information. Note: The FastEthernet option is not supported on S-Series. (OPTIONAL) Enter the keyword all to display information on all interfaces. (OPTIONAL) Enter the keyword events to display major events such as timer events. (OPTIONAL) Enter the keyword packet to display information regarding packets coming in or going out. (OPTIONAL) Enter the keyword brief to display brief packet information. (OPTIONAL) Enter the keyword detail to display detailed packet information. (OPTIONAL) Enter the keyword tx to display transmit only packet information. (OPTIONAL) Enter the keyword rx to display receive only packet information (OPTIONAL) Enter the keyword both to display both receive and transmit packet information. Defaults No default values or behavior Command Modes EXEC Privilege Command History Version 8.3.5.0 Version 7.7.1.0 Version 7.6.1.0 Version 7.4.1.0 Introduced on the S55. Introduced on S-Series Introduced on C-Series Introduced on E-Series disable c e s Enable or disable LLDP. Syntax disable To enable LLDP, use the no disable Defaults Enabled, that is no disable Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Command History Version 8.3.5.0 Version 7.7.1.0 Version 7.6.1.0 Version 7.4.1.0 Introduced on the S55. Introduced on S-Series Introduced on C-Series Introduced on E-Series Link Layer Detection Protocol (LLDP) | 651