Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 885
Remote Monitoring (RMON), Overview, Commands
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 885 highlights
34 Remote Monitoring (RMON) Overview FTOS RMON is implemented on all Dell Force10 switching platforms (C-Series, E-Series, and S-Series), as indicated by the characters that appear below each command heading: • C-Series: c • E-Series: e • S-Series: s FTOS RMON is based on IEEE standards, providing both 32-bit and 64-bit monitoring, and long-term statistics collection. FTOS RMON supports the following RMON groups, as defined in RFC-2819, RFC-3273, and RFC-3434: • Ethernet Statistics Table • Ethernet Statistics High-Capacity Table • Ethernet History Control Table • Ethernet History Table • Ethernet History High-Capacity Table • Alarm Table • High-Capacity Alarm Table (64bits) • Event Table • Log Table RFC-2819 RFC-3273, 64bits RFC-2819 RFC-2819 RFC-3273, 64bits RFC-2819 RFC-3434, 64bits RFC-2819 RFC-2819 FTOS RMON does not support the following statistics: • etherStatsCollisions • etherHistoryCollisions • etherHistoryUtilization Note: Only SNMP GET/GETNEXT access is supported. Configure RMON using the RMON commands. Collected data is lost during a chassis reboot. Commands The FTOS Remote Network Monitoring RMON commands are: • rmon alarm • rmon collection history • rmon collection statistics • rmon event Remote Monitoring (RMON) | 885