Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 497

speed (Management interface) c e Set the speed for the Management interface. Syntax speed {10 | 100 | auto} To return to the default setting, use the no speed {10 | 100} command. Parameters 10 100 auto Enter the keyword 10 to set the interface's speed to 10 Mb/s. Enter the keyword 100 to set the interface's speed to 100 Mb/s. Enter the keyword auto to set the interface to auto-negotiate its speed. Defaults auto Command Modes INTERFACE Command History Version 8.1.1.0 Version 7.5.1.0 pre-Version 6.2.1.0 Introduced on E-Series ExaScale Introduced on C-Series Introduced for E-Series Usage This command is found on the Management interface only. Information Related Commands interface ManagementEthernet duplex (Management) management route Configure the Management port on the system (either the Primary or Standby RPM). Set the mode of the Management interface. Configure a static route that points to the Management interface or a forwarding router. switchport c e s Place the interface in Layer 2 mode. Syntax switchport [backup interface {gigabit | tengigabit} slot/port] To remove the interface from Layer 2 mode and place it in Layer 3 mode, enter no switchport. If a switchport backup relationship exists, remove that relationship first. To remove a switchport backup relationship created on this port, enter no switchport backup interface {gigabit | tengigabit} slot/port]. Parameters backup interface gigabit tengigabit slot/port Use this option to configure a redundant Layer 2 link without using Spanning Tree. This keyword configures a backup port so that if the primary port fails the backup port changes to the up state. If the primary later comes up, it becomes the backup. Enter this keyword if the backup port is a 1G port. Enter this keyword if the backup port is a 10G port. Specify the line card and port number of the backup port. Defaults Disabled (The interface is in Layer 3 mode.) Interfaces | 497