Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 522

www.dell.com | support.dell.com Usage You must be in the INTERFACE mode before you add an IP address to an interface. Assign an IP Information address to an interface prior to entering the ROUTER OSPF mode. ip directed-broadcast c e s Enables the interface to receive directed broadcast packets. Syntax ip directed-broadcast To disable the interface from receiving directed broadcast packets, enter no ip directed-broadcast. Defaults Disabled (that is, the interface does not receive directed broadcast packets) Command Modes INTERFACE Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced on the S55. Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series ip domain-list c e s Configure names to complete unqualified host names. Syntax ip domain-list name To remove the name, use the no ip domain-list name command. Parameters name Enter a domain name to be used to complete unqualified names (that is, incomplete domain names that cannot be resolved). Defaults Disabled. Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced on the S55. Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Usage Information Configure the ip domain-list command up to 6 times to configure a list of possible domain names. If both the ip domain-name and ip domain-list commands are configured, the software will try to resolve the name using the ip domain-name command. If the name is not resolved, the software goes through the list of names configured with the ip domain-list command to find a match. Use the following steps to enable dynamic resolution of hosts: • specify a domain name server with the ip name-server command. • enable DNS with the ip domain-lookup command. 522 | IPv4 Routing