Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 967

Version 7.7.1.0 Version 7.6.1.0 Version 6.5.1.0 Version 6.2.1.1 Introduced on S-Series Introduced on C-Series Expanded the no form of the command to mirror the syntax used to configure Introduced on E-Series Usage Information You can specify up to 2 sFlow collectors. If 2 collectors are specified, the samples are sent to both. As part of the sFlow-MIB, if the SNMP request originates from a configured collector, FTOS will return the corresponding configured agent IP in MIB requests. FTOS checks to ensure that two entries are not configured for the same collector IP with a different agent IP. Should that happen, FTOS generates the following error: %Error: Different agent-addr attempted for an existing collector sflow enable (Global) c e s Enable sFlow globally. Syntax sflow enable To disable sFlow, use the no sflow enable command. Defaults sFlow is disabled by default Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.2.1.0 Version 8.1.1.0 Version 7.7.1.0 Version 7.6.1.0 Version 6.2.1.1 Introduced on S55 Introduces on S-Series Stacking Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage sFlow is disabled by default. In addition to this command, sFlow needs to be enable on individual Information interfaces where sFlow sampling is desired. Related Commands sflow enable (Interface) Enable sFlow on Interfaces. sflow enable (Interface) c e s Enable sFlow on Interfaces. Syntax sflow enable To disable sFlow, use the no sflow enable command. Defaults sFlow is disabled by default on all interfaces Command Modes INTERFACE sFlow | 967