Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 999
logging source-interface, logging synchronous
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 999 highlights
logging source-interface c e s Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog server. Syntax logging source-interface interface To disable this command and return to the default setting, enter no logging source-interface. Parameters interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interfaces, enter the keyword loopback followed by a number from zero (0) to 16383. • For the management interface on the RPM, enter the keyword ManagementEthernet followed by the slot/port information. The slot range is 0-1 and the port range is 0. • For a Port Channel, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1-255 for TeraScale, • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.3.5.0 Introduced on S55 Version 7.6.1.0 Support added for S-Series Version 7.5.1.0 Support added for C-Series E-Series legacy command Usage Information Syslog messages contain the IP address of the interface used to egress the router. By configuring the logging source-interface command, the Syslog packets contain the IP address of the interface configured. Related Commands logging Enable the logging to another device. logging synchronous c e s Synchronize unsolicited messages and FTOS output. Syntax logging synchronous [level level | all] [limit number-of-buffers] To disable message synchronization, use the no logging synchronous [level level | all] [limit number-of-buffers] command. SNMP and Syslog | 999