Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 867
debug ip rip, default-information originate
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 867 highlights
debug ip rip c e s Examine RIP routing information for troubleshooting. Syntax Parameters debug ip rip [interface | database | events [interface] | packet [interface] | trigger] To turn off debugging output, use the no debug ip rip command. interface database events packet trigger (OPTIONAL) Enter the interface type and ID as one of the following: • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel, enter the keyword port-channel followed by a number from 1 to 32 for EtherScale, 1 to 255 for TeraScale, 1-128 on C-Series and S-Series. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Note: This option is available only on E-Series when entered as a standalone option. It is available on both C-Series and E-Series as a sub-option. (OPTIONAL) Enter the keyword database to display messages when there is a change to the RIP database. (OPTIONAL) Enter the keyword events to debug only RIP protocol changes. (OPTIONAL) Enter the keyword events to debug only RIP protocol packets. Note: This option is available only on C-Series. (OPTIONAL) Enter the keyword trigger to debug only RIP trigger extensions. Command Modes Command History EXEC Privilege Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series default-information originate c e s Generate a default route for the RIP traffic. Syntax Parameters default-information originate [always] [metric metric-value] [route-map map-name] To return to the default values, enter no default-information originate. always (OPTIONAL) Enter the keyword always to enable the switch software to always advertise the default route. Router Information Protocol (RIP) | 867