Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 764

www.dell.com | support.dell.com Parameters ext-access-list in out Enter the name of an extended access list. Enter this keyword to apply the access list to inbound traffic. Enter this keyword to apply the access list to outbound traffic. Defaults None Command Modes INTERFACE Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on S55 Introduced on E-Series ExaScale Introduced on C-Series on port-channels and S-Series Introduced on E-Series. Example Figure 27-1. ip pim join-filter Command Example Force10(conf)# ip access-list extended iptv-channels Force10(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24 Force10(config-ext-nacl)# permit ip any 232.1.1.0/24 Force10(config-ext-nacl)# permit ip 100.1.1.0/16 any Force10(config-if-gi-1/1)# ip pim join-filter iptv-channels in Force10(config-if-gi-1/1)# ip pim join-filter iptv-channels out Related Commands ip access-list extended Configure an access list based on IP addresses or protocols. ip pim neighbor-filter c e s Configure this feature to prevent a router from participating in protocol independent Multicast (PIM). Syntax ip pim neighbor-filter {access-list} To remove the restriction, use the no ip pim neighbor-filter {access-list} command. Parameters access-list Enter the name of a standard access list. Maximum 16 characters. Defaults Defaults. Command Modes CONFIGURATION. Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.8.1.0 Version 7.6.1.0 Introduced on S55 Introduced on E-Series ExaScale Introduced on C-Series and S-Series Introduced on the E-Series Usage Do not enter this command before creating the access-list. Information 764 | PIM-Sparse Mode (PIM-SM)