Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 462
ipg 10 Gigabit Ethernet interfaces, interface vlan Command Example
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 462 highlights
www.dell.com | support.dell.com Example Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.0 Introduced on S-Series Introduced on C-Series Introduced for E-Series Figure 15-17. interface vlan Command Example Force10(conf)#int vlan 3 Force10(conf-if-vl-3)# Usage For more information on VLANs and the commands to configure them, refer to Virtual LAN (VLAN) Information Commands. FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in VLANs. IP ACLs are supported. See Chapter 7, Access Control Lists (ACL). Related Commands interface interface loopback interface null interface port-channel show vlan shutdown tagged untagged Configure a physical interface. Configure a loopback interface. Configure a null interface. Configure a port channel group. Display the current VLAN configuration on the switch. Disable/Enable the VLAN. Add a Layer 2 interface to a VLAN as a tagged interface. Add a Layer 2 interface to a VLAN as an untagged interface. ipg (10 Gigabit Ethernet interfaces) e Set the Inter-packet Gap for traffic on 10 Gigabit Ethernet interface. Syntax ipg {ieee-802.3ae | shrink} To return to the default of averaging the IPG, enter no ipg {shrink | ieee-802.3ae} Parameters ieee-802.3ae shrink Enter the keyword ieee-802.3ae to set the IPG to 12 (12-15) bytes (packet size dependent) Enter the keyword shrink to set the IPG to 8 (8-11) bytes (packet size dependent). Defaults averaging the IPG Command Modes INTERFACE Command History pre-Version 6.1.1.0 Introduced for E-Series Usage Information For 10 Gigabit Ethernet interfaces only. IPG equals 96 bits times from end of the previous packet to start of the pre-amble of the next packet. 462 | Interfaces