Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 613
lacp long-timeout, lacp port-priority
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 613 highlights
lacp long-timeout c e Configure a long timeout period (30 seconds) for an LACP session. Syntax lacp long-timeout To reset the timeout period to a short timeout (1 second), use the no lacp long-timeout command. Defaults 1 second Command Modes INTERFACE (conf-if-po-number) Command History Version 8.3.5.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.5.1.0 Introduced on the S55. Support added for S-Series Support added for C-Series Introduced on E-Series Usage This command applies to dynamic port-channel interfaces only. When applied on a static port-channel, Information the command has no effect. Related Commands show lacp Display the lacp configuration lacp port-priority c e s Configure the port priority to influence which ports will be put in standby mode when there is a hardware limitation that prevents all compatible ports from aggregating. Syntax lacp port-priority priority-value To return to the default setting, use the no lacp port-priority priority-value command. Parameters priority-value Enter the port-priority value. The higher the value number the lower the priority. Range: 1 to 65535 Default: 32768 Defaults 32768 Command Modes INTERFACE Command History Version 8.3.5.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.2.1.1 Introduced on the S55. Support added for S-Series Support added for C-Series Introduced on E-Series Link Aggregation Control Protocol (LACP) | 613