Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 873
ip split-horizon, maximum-paths
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 873 highlights
Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage To enable the interface to send both version of RIP packets, enter ip rip send version 1 2. Information Related Commands ip rip receive version version Sets the RIP version for the interface to receive traffic. Sets the RIP version to be used for the switch software. ip split-horizon c e s Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme prevents any routes learned over a specific interface to be sent back out that interface. Syntax ip split-horizon To disable split-horizon, enter no ip split-horizon. Defaults Enabled Command Modes INTERFACE Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Related Commands ip poison-reverse Set the prefix for RIP routing updates. maximum-paths c e s Set RIP to forward packets over multiple paths. Syntax Parameters maximum-paths number To return to the default values, enter no maximum-paths. number Enter the number of paths. Range: 1 to 16. The default is 4 paths. Defaults 4 Command Modes ROUTER RIP Router Information Protocol (RIP) | 873