Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 757
summary-address, Command Example, Table 26-14., Command Example Descriptions
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 757 highlights
Example Figure 26-20. Command Example: show ip ospf process-id virtual-links Force10#show ip ospf 1 virt Virtual Link to router 192.168.253.5 is up Run as demand circuit Transit area 0.0.0.1, via interface GigabitEthernet 13/16, Cost of using 2 Transmit Delay is 1 sec, State POINT_TO_POINT, Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5 Hello due in 00:00:02 Force10# Table 26-14. Command Example Descriptions: show ip ospf process-id virtual-links Items "Virtual Link..." "Run as..." "Transit area..." "Transmit Delay..." "Timer intervals..." "Hello due..." "Adjacency State..." Description This line specifies the OSPF neighbor to which the virtual link was created and the link's status. This line states the nature of the virtual link. This line identifies the area through which the virtual link was created, the interface used, and the cost assigned to that link. This line displays the transmit delay assigned to the link and the State of the OSPF neighbor. This line displays the timer values assigned to the virtual link. The timers are Hello is hello-interval, Dead is dead-interval, Wait is transmit-delay, and Retransmit is retransmit-interval. This line displays the amount of time until the next Hello packet is expected from the neighbor router. This line displays the adjacency state between neighbors. summary-address c e s Set the OSPF ASBR to advertise one external route. Syntax Parameters summary-address ip-address mask [not-advertise] [tag tag-value] To disable summary address, use the no summary-address ip-address mask command. ip-address mask not-advertise tag tag-value Specify the IP address in dotted decimal format of the address to be summarized. Specify the mask in dotted decimal format of the address to be summarized. (OPTIONAL) Enter the keyword not-advertise to suppress that match the network prefix/mask pair. (OPTIONAL) Enter the keyword tag followed by a value to match on routes redistributed through a route map. Range: 0 to 4294967295 Defaults Command Modes Not configured. ROUTER OSPF Open Shortest Path First (OSPFv2 and OSPFv3) | 757