Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 594
ipv6 unicast-routing, Command Example
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 594 highlights
www.dell.com | support.dell.com Defaults No default values or behavior Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced on the S55. Introduced on E-Series ExaScale Introduced on C-Series and S-Series Introduced Example Figure 18-2. Command Example: ipv6 route Force10(conf)#ipv6 route 44::0 /64 33::1 ? Distance metric for this route permanent Permanent route tag Set tag for this route Force10(conf)#ipv6 route 55::0 /64 ? X:X:X:X::X Forwarding router's address gigabitethernet Gigabit Ethernet interface loopback Loopback interface null Null interface port-channel Port channel interface sonet Sonet interface tenGigabitethernet TenGigabit Ethernet interface vlan VLAN interface Force10(conf)#ipv6 route 55::0 /64 gigabitethernet 9/0 ? Distance metric for this route X:X:X:X::X Forwarding router's address permanent Permanent route tag Set tag for this route Force10(conf)#ipv6 route 55::0 /64 gigabitethernet 9/0 66::1 ? Distance metric for this route permanent Permanent route tag Set tag for this route Force10# Usage Information Related Commands When the interface goes down, FTOS withdraws the route. The route is re-installed, by FTOS, when the interface comes back up. When a recursive resolution is "broken," FTOS withdraws the route. The route is re-installed, by FTOS, when the recursive resolution is satisfied. show ipv6 route View the IPv6 configured routes. ipv6 unicast-routing c e Enable IPv6 unicast routing. Syntax ipv6 unicast-routing To disable unicast routing, use the no ipv6 unicast-routing command. Defaults Enabled 594 | IPv6 Basics