Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 1026
stack-unit renumber
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1026 highlights
www.dell.com | support.dell.com Command Modes CONFIGURATION Command History Version 8.3.5.1 Version 7.7.1.0 Introduced on S55 Introduced on S-Series Usage The S60 and the S60 do not support stacking with other platforms. You can only stack the S60 with Information other S60 systems and the S55 with other S55 systems. Related Commands reload show system (S-Series) Reboot FTOS. Display the current status of all stack members or a specific member. stack-unit renumber s Change the stack member ID of any stack member or a stand-alone S-Series. Syntax stack-unit stack-unit renumber stack-unit Parameters stack-unit Enter the stack member unit identifier of the stack member to reset. S55 range: 0 - 11 The first instance of this value is the stack member unit identifier, from 0 to 11, of the switch that you want add to the stack. The second instance of this value is the desired new unit identifier number. Defaults none Command Modes EXEC Privilege Command History Version 8.3.5.1 Version 7.7.1.0 Introduced on S55 Introduced on S-Series Usage Information You can renumber any switch, including the management unit or a stand-alone unit. You cannot renumber a unit to a number of an active member in the stack. When executing this command on the master, the stack reloads. When the members are renumbered, only that specific unit will reset and come up with the new unit number. Example Figure 41-11. stack-unit renumber Command Example Force10#stack-unit 0 renumber 2 Renumbering master unit will reload the stack. Proceed to renumber [confirm yes/ no]: Related Commands reload reset stack-unit show system (S-Series) Reboot FTOS. Reset the designated S-Series stack member. Display the current status of all stack members or a specific member. 1026 | S-Series Stacking Commands