Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 81

Related Commands ip ssh server Enable SSH server on the system. ip telnet source-interface c e s Set an interface's IP address as the source address in outgoing packets for Telnet sessions. Syntax ip telnet source-interface interface To return to the default setting, use the no ip telnet source-interface [interface] command. Parameters interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interfaces, enter the keyword loopback followed by a number from zero (0) to 16383. • For the SONET interfaces, enter the keyword sonet followed by slot/port information. • For a Port Channel, enter the keyword port-channel followed by a number: C-Series and S-Series: 1-128 E-Series: 1 to 255 for TeraScale and ExaScale • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets. Command Modes CONFIGURATION Command History Version 8.3.5.0 Introduced on the S55. Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094) Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.6.1.0 Support added for S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command Related Commands telnet Telnet to another device. ip tftp source-interface c e s Assign an interface's IP address in outgoing packets for TFTP traffic. Syntax ip tftp source-interface interface To return to the default setting, use the no ip tftp source-interface interface command. Control and Monitoring | 81