Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 498

www.dell.com | support.dell.com Command Modes INTERFACE Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.7.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.0 Introduced on the S55. Introduced on E-Series ExaScale Added backup interface option. Introduced on S-Series Introduced on C-Series Introduced for E-Series Usage Information If an IP address or VRRP group is assigned to the interface, you cannot use the switchport command for that interface. To use the switchport command on an interface, only the no ip address and no shutdown statements must be listed in the show config for that command. When you enable the switchport command, the interface is automatically added to the Default VLAN. To use the switchport backup interface command on a port, first execute the switchport command on the port. For details, see the section Configuring Redundant Links in the Layer 2 chapter of the FTOS Configuration Guide. Related Commands interface port-channel show interfaces switchport Create a port channel interface. Display information about switchport interfaces. wanport e Enable the WAN mode on a TenGigabitEthernet interface. Syntax wanport To disable the WAN Port, enter no wanport. Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.1.1.2 pre-Version 6.2.1.0 Introduced on E-Series ExaScale Introduced for E-Series Usage The port must be in a shutdown state to change from LAN mode to WAN mode and vice-versa as Information shown in the figure below. For E-Series ExaScale systems, you must configure all the ports in a port-pipe to either WANPHY or non-WANPHY. They cannot be mixed on the same port-pipe. 498 | Interfaces