Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 461

interface range macro name c e s Run the interface-range macro to automatically configure the pre-defined range of interfaces. Syntax interface range macro name Parameters name Enter the name of an existing macro. Defaults This command has no default behavior or value Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.2.1.1 Introduced on the S55. Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced Usage Figure 15-16 runs the macro named test that was defined in Figure 15-15. Information Example Figure 15-16. interface-range macro Command Example Force10(config)#interface range macro test Force10(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)# Force10 Related Commands interface range interface range macro (define) Configure a range of command (bulk configuration) Define a macro for an interface range (bulk configuration) interface vlan c e s Configure a VLAN. You can configure up to 4094 VLANs. Syntax interface vlan vlan-id To delete a VLAN, use the no interface vlan vlan-id command. Parameters vlan-id Enter a number as the VLAN Identifier. Range: 1 to 4094. Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1. Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.2.1.0 Version 8.1.1.0 Introduced on the S55. Support for 4093 VLANs on E-Series ExaScale. Prior releases supported 2094. Introduced on E-Series ExaScale Interfaces | 461