Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 570

www.dell.com | support.dell.com implicit-permit vlan range (OPTIONAL) Enter the keyword implicit-permit to change the default action of the IPv6 ACL from implicit-deny to implicit-permit (that is, if the traffic does not match the filters in the IPv6 ACL, the traffic is permitted instead of dropped). (OPTIONAL) Enter the keyword vlan followed by the VLAN range in a comma separated format. Range: 1 to 4094 Defaults Disabled Command Modes INTERFACE Command History Version 7.8.1.0 Version 7.4.1.0 Introduced support on the C-Series Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Introduced support on the E-Series Usage Information The S-Series supports Ingress IPv6 ACLs. The S55 supports both Ingress and Egress IPv6 ACLs. You can assign an IPv6 access group to a physical, LAG, or VLAN interface context. Example Figure 17-1. Command Example: ipv6 access-group Force10(conf-if-gi-9/0)#ipv6 access-group AclList1 in implicit-permit vlan 10-20 Force10(conf-if-gi-9/0)#show config ! interface GigabitEthernet 9/0 no ip address ipv6 access-group AclList1 in implicit-permit Vlan 10-20 no shutdown Force10conf-if-gi-9/0)# ipv6 access-list c e s Configure an access list based on IPv6 addresses or protocols. Syntax ipv6 access-list access-list-name To delete an access list, use the no ipv6 access-list access-list-name command. Parameters access-list-name Enter the as the access list name as a string, up to 140 characters. Defaults All access lists contain an implicit "deny any"; that is, if no match occurs, the packet is dropped. Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.2.1.0 Introduced support on the S55. Introduced support on the E-Series ExaScale 570 | IPv6 Access Control Lists (IPv6 ACLs)