Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 1021

Figure 41-4. show redundancy (S55) Force110#show redundancy -- Stack-unit Status -- Mgmt ID: 0 Stack-unit ID: 0 Stack-unit Redundancy Role: Primary Stack-unit State: Active Stack-unit SW Version: E8-3-5-34 Link to Peer: Up -- PEER Stack-unit Status -- Stack-unit State: Standby Peer stack-unit ID: 1 Stack-unit SW Version: E8-3-5-34 -- Stack-unit Redundancy Configuration -- Primary Stack-unit: mgmt-id 0 Auto Data Sync: Full Failover Type: Hot Failover Auto reboot Stack-unit: Enabled Auto failover limit: 3 times in 60 minutes -- Stack-unit Failover Record -- Failover Count: 0 Last failover timestamp: None Last failover Reason: None Last failover type: None -- Last Data Block Sync Record: -- Stack Unit Config: succeeded Jan 16 2011 04:29:22 Start-up Config: succeeded Jan 16 2011 04:29:22 Runtime Event Log: succeeded Jan 16 2011 04:20:39 Running Config: succeeded Jan 16 2011 04:20:43 ACL Mgr: succeeded Jan 16 2011 04:20:39 LACP: no block sync done STP: no block sync done SPAN: no block sync done Force10# Related Commands redundancy disable-auto-reboot Prevent the system from auto-rebooting if it fails. show system stack-ports s Display information about the stacking ports on all switches in the S-Series stack. Syntax show system stack-ports [status | topology] Parameters status topology (OPTIONAL) Enter the keyword status to display the command output without the Connection field. (OPTIONAL) Enter the keyword topology to limit the table to just the Interface and Connection fields. Defaults No default behavior S-Series Stacking Commands | 1021