Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 823

match ip precedence c e s Use IP precedence values as a match criteria. Syntax match ip precedence ip-precedence-list [[multicast] set-ip-dscp value] To remove IP precedence as a match criteria, enter no match ip precedence ip-precedence-list [[multicast] set-ip-dscp value] command. Parameters ip-precedence-list multicast set-ip-dscp value Enter the IP precedence value(s) as the match criteria. Separate values by commas-no spaces (1,2,3) or indicate a list of values separated by a hyphen (1-3). Range: 0 to 7 (OPTIONAL) Enter the keyword multicast to match against multicast traffic. Note: This option is not supported on C-Series or S-Series. (OPTIONAL) Enter the keyword set-ip-dscp followed by the IP DSCP value. The matched traffic will be marked with the DSCP value. Range: 0 to 63 Note: This option is not supported on S-Series. Defaults No default behavior or values Command Modes CLASS-MAP CONFIGURATION (conf-class-map) Command History Version 8.3.5.0 Version 7.7.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.2.1.1 Introduced on S55 Added keyword multicast. Added DSCP marking option support for S-Series Introduced on S-Series Introduced on C-Series Added support for DSCP Marking option Introduced on E-Series Usage You must enter the class-map command in order to access this command. Once the class map is Information identified, you can configure the match criteria. The match ip precedence command and the match ip dscp command are mutually exclusive. Up to eight precedence values can be matched in one match statement. For example, to indicate the IP precedence values 0 1 2 3 enter either the command match ip precedence 0-3 or match ip precedence 0,1,2,3. Note: Only one of the IP precedence values must be a successful match criterion, not all of the specified IP precedence values need to match. Related Commands class-map Identify the class map. Quality of Service (QoS) | 823