Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 151

util-threshold cpu (C- and E-Series) c e Configure the high or low CPU utilization thresholds for SNMP traps. Syntax util-threshold cpu {5sec | 1min | 5min} {rp1 | rp2 | cp | lp slot-id | all} {high {0-100} | {low [0-100}} To return to the default settings, use the no util-threshold cpu command syntax. Parameters cpu utilization time processor type utilization threshold in % Indicate the length of time in which the cpu has been busy. • 5sec • 1min • 5min Indicate the type of processor to be used to configure the CPU utilization information. • rp1 = route processor1 • rp2 = route processor2 • cp = control processor • lp slot-id = the line card slot-id • all = use all of the processors to configure the CPU utilization information. Indicate the high or low values for the CPU utilization thresholds in percentage format. • high. Range: 0 - 100 • low. Range: 0 - 100 Note: A threshold level of 0 will disable the syslog and SNMP trap. Example util-threshold cpu 5sec cp high 50 Defaults Command Modes Command History In this example, the low threshold value is not specified so it will take the value set for the high threshold value.In all other instances, the low threshold value must be equal to or less than that of the high threshold value. High CPU utilization threshold: 1min = 85%, 5min = 80% Low CPU utilization threshold: 1min = 75%, 5min = 70% CONFIG Version 8.4.2.3 Version 8.4.2.0 Version 8.4.1.0 Introduced on C-Series, S25 and S50 Introduced on E-Series TeraScale Introduced on E-Series ExaScale Usage Information Related Commands When the total CPU utilization exceeds the configured threshold for a given time, a threshold notification is sent as a SNMP trap. If a low threshold value is not specified, the low threshold value is set to the same value as the high threshold value. The system will generate a SYSLOG and SNMP Trap each time the configured threshold is crossed. Note: The 5sec util-threshold cpu command is disabled by default on all platforms. To enable the command, enter util-threshold cpu 5sec all high {value greater than zero}. To disable the SYSLOG and traps for the 5sec cpu utilization thresholds, enter util-threshold cpu 5sec all high 0 or no util-threshold cpu 5sec {rp1 | rp2 | cp | lp slot-id | all} show util-threshold mem Display the set values of the memory utilization thresholds Control and Monitoring | 151