Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 350
neighbor default-originate, neighbor distribute-list
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 350 highlights
www.dell.com | support.dell.com Defaults Command Modes Command History seconds = 5 seconds (internal peers); seconds = 30 seconds (external peers) ROUTER BGP Address Family (conf-router_bgp_af) Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series neighbor default-originate c et s Inject the default route to a BGP peer or neighbor. Syntax neighbor {ip-address | peer-group-name} default-originate [route-map map-name] To remove a default route, use the no neighbor {ip-address | peer-group-name} default-originate command. Parameters ip-address peer-group-name route-map map-name Enter the IP address of the neighbor in dotted decimal format. Enter the name of the peer group to set the default route of all routers in that peer group. (OPTIONAL) Enter the keyword route-map followed by the name of a configured route map. Defaults Not configured. Command Modes ROUTER BGP Address Family (conf-router_bgp_af) Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series neighbor distribute-list c et s Distribute BGP information via an established prefix list. Syntax neighbor [ip-address | peer-group-name] distribute-list prefix-list-name [in | out] To delete a neighbor distribution list, use the no neighbor [ip-address | peer-group-name] distribute-list prefix-list-name [in | out] command. Parameters ip-address peer-group-name prefix-list-name in out Enter the IP address of the neighbor in dotted decimal format. Enter the name of the peer group to apply the distribute list filter to all routers in the peer group. Enter the name of an established prefix list. If the prefix list is not configured, the default is permit (to allow all routes). Enter the keyword in to distribute only inbound traffic. Enter the keyword out to distribute only outbound traffic. 350 | Border Gateway Protocol IPv4(BGPv4)