Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 495
shutdown, speed for 10/100/1000 interfaces
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 495 highlights
Related Commands interface show ip interface show interfaces Configure a physical interface on the switch. Displays Layer 3 information about the interfaces. Display information on a specific physical interface or virtual interface. shutdown c e s Disable an interface. Syntax shutdown To activate an interface, enter no shutdown. Defaults The interface is disabled. Command Modes INTERFACE Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 E-Series legacy command Introduced on the S55. Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Usage The shutdown command marks a physical interface as unavailable for traffic. To discover if an Information interface is disabled, use the show ip interface brief command. Disabled interfaces are listed as down. Disabling a VLAN or a port channel causes different behavior. When a VLAN is disabled, the Layer 3 functions within that VLAN are disabled. Layer 2 traffic continues to flow. Entering the shutdown command on a port channel disables all traffic on the port channel and the individual interfaces within the port channel. To enable a port channel, you must enter no shutdown on the port channel interface and at least one interface within that port channel. The shutdown and description commands are the only commands that you can configure on an interface that is a member of a port channel. Related Commands interface port-channel interface vlan show ip interface Create a port channel interface. Create a VLAN. Displays the interface routing status. Add the keyword brief to display a table of interfaces and their status. speed (for 10/100/1000 interfaces) c e s Set the speed for 10/100/1000 Base-T Ethernet interfaces. Both sides of a link must be set to the same speed (10/100/1000) or to auto or the link may not come upSyntax speed {10 | 100 | 1000 | auto} To return to the default setting, use the no speed {10 | 100 | 1000} command. Interfaces | 495