Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 311

Usage Information In the FTOS best path selection process, the path with the highest weight value is preferred. Note: Reset the neighbor connection (clear ip bgp * command) to apply the weight to the connection and recompute the best path. Related Commands Command History If the set weight command is configured in a route map applied to this neighbor, the weight set in that command overrides the weight set in the neighbor weight command. set weight Assign a weight to all paths meeting the route map criteria. Version 8.3.5.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S55. Introduced support on S-Series Introduced support on C-Series network c e s Specify the networks for the BGP process and enter them in the BGP routing table. Syntax network ip-address mask [route-map map-name] To remove a network, use the no network ip-address mask [route-map map-name] command. Parameters ip-address mask route-map map-name Enter an IP address in dotted decimal format of the network. Enter the mask of the IP address in the slash prefix length format (for example, /24). The mask appears in command outputs in dotted decimal format (A.B.C.D). (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ip address • set community • set local-preference • set metric • set next-hop • set origin • set weight If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Command Modes ROUTER BGP Usage Information FTOS software resolves the network address configured by the network command with the routes in the main routing table to ensure that the networks are reachable via non-BGP routes and non-default routes. Related Commands redistribute Redistribute routes into BGP. Border Gateway Protocol IPv4(BGPv4) | 311