Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 614

www.dell.com | support.dell.com lacp system-priority c e s Configure the LACP system priority. Syntax lacp system-priority priority-value To return to the default setting, use the no lacp system-priority priority-value command. Parameters priority-value Enter the port-priority value. The higher the value, the lower the priority. Range: 1 to 65535 Default: 32768 Defaults 32768 Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.2.1.1 Introduced on the S55. Support added for S-Series Support added for C-Series Introduced on E-Series lacp ungroup member-independent Enable BMP boot for the device connected to the LACP LAG. Syntax Defaults Command Modes Usage Information Command History lacp ungroup member-independent {port-channel port-channel-id} Not configured. CONFIGURATION During boot-up in a stacking configuration, the system must be able to reach the DHCP server with the image and configuration image. During bootup, only untagged DHCP requests are sent to the DHCP server to receive an offer on static LAGs between switches. The DHCP server must be configured to start in jumpstart mode. If switches are connected using LACP port-channel like ToR, use the port-channel parameter on the TOR side of the configuration to allow member ports of a completely un-grouped lacp port-channel to inherit vlan membership of that port channel to ensure untagged packets reach the DHCP server located on the TOR. To ungroup the port-channel configurations, use the no lacp ungroup member-independent command. Version 8.3.5.3 Version 8.3.3.8 Version 8.3.12.0 Version 8.3.8.0 Introduced on S55 Introduced on S60 Added port-channel parameter. Introduced on S4810 614 | Link Aggregation Control Protocol (LACP)