Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 23

RAPID SPANNING TREE Mode Use PVST+ mode to enable and configure the RSTP protocol, as described in Chapter 35, Rapid Spanning Tree Protocol (RSTP). To enter RSTP mode: 1. Verify that you are logged into the CONFIGURATION mode. 2. Enter the protocol spanning-tree rstp command. You can return to the CONFIGURATION mode by entering the exit command. MULTIPLE SPANNING TREE Mode Use MULTIPLE SPANNING TREE mode to enable and configure the Multiple Spanning Tree protocol, as described in Chapter 23, Multiple Spanning Tree Protocol (MSTP). To enter MULTIPLE SPANNING TREE mode: 1. Verify that you are logged into the CONFIGURATION mode. 2. Enter the protocol spanning-tree mstp command. You can return to the CONFIGURATION mode by entering the exit command. PROTOCOL GVRP Mode Use the PROTOCOL GVRP mode to enable and configure GARP VLAN Registration Protocol (GVRP), as described in Chapter 13, GARP VLAN Registration (GVRP). To enter PROTOCOL GVRP mode: 1. Verify that you are logged into the CONFIGURATION mode. 2. Enter the protocol gvrp command syntax. You can return to the CONFIGURATION mode by entering the exit command. ROUTER OSPF Mode Use the ROUTER OSPF mode to configure OSPF, as described in Chapter 26, Open Shortest Path First (OSPFv2 and OSPFv3). To enter ROUTER OSPF mode: 1. Verify that you are logged into the CONFIGURATION mode. 2. Use the router ospf {process-id} command.The prompt changes to include (conf-router_ospf-id). You can switch to the INTERFACE mode by using the interface command or you can switch to the ROUTER RIP mode by using the router rip command. CLI Basics | 23