Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 875

Command Modes ROUTER RIP Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Information You can enable an unlimited number of RIP networks. RIP operates over interfaces configured with any address specified by the network command. offset-list c e s Specify a number to add to the incoming or outgoing route metrics learned via RIP. Syntax Parameters offset-list prefix-list-name {in | out} offset [interface] To delete an offset list, use the no offset-list prefix-list-name {in | out} offset [interface] command. prefix-list-name offset interface Enter the name of an established Prefix list to determine which incoming routes will be modified. Enter a number from zero (0) to 16 to be applied to the incoming route metric matching the access list specified. If you set an offset value to zero (0), no action is taken. (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number from 1 to 32 for EtherScale, 1 to 255 for TeraScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Defaults Not configured. Command Modes ROUTER RIP Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage When the offset metric is applied to an interface, that value takes precedence over an offset value that Information is not extended to an interface. Related Commands ip prefix-list Enter the PREFIX-LIST mode and configure a prefix list. Router Information Protocol (RIP) | 875