Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 282

www.dell.com | support.dell.com Example Figure 8-2. Command Example: no bgp regex-eval-optz-disable Force10(conf-router_bgp)#no bgp regex-eval-optz-disable Force10(conf-router_bgp)#do show ip protocols Routing Protocol is "ospf 22222" Router ID is 2.2.2.2 Area Routing for Networks 51 10.10.10.0/00 Routing Protocol is "bgp 1" Cluster Id is set to 10.10.10.0 Router Id is set to 10.10.10.0 Fast-external-fallover enabled Regular expression evaluation optimization enabled Capable of ROUTE_REFRESH For Address Family IPv4 Unicast BGP table version is 0, main routing table version 0 Distance: external 20 internal 200 local 200 Force10(conf-router_bgp)# bgp router-id c e s Assign a user-given ID to a BGP router. Syntax bgp router-id ip-address To delete a user-assigned IP address, enter no bgp router-id. Parameters ip-address Enter an IP address in dotted decimal format to reset only that BGP neighbor. Defaults The router ID is the highest IP address of the Loopback interface or, if no Loopback interfaces are configured, the highest IP address of a physical interface on the router. Command Modes ROUTER BGP Usage Peering sessions are reset when you change the router ID of a BGP router. Information Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S55. Introduced support on S-Series Introduced support on C-Series bgp soft-reconfig-backup c e s Use this command only when route-refresh is not negotiated to avoid the peer from resending messages. Syntax bgp soft-reconfig-backup To return to the default setting, use the no bgp soft-reconfig-backup command. Defaults Off Command Modes ROUTER BGP 282 | Border Gateway Protocol IPv4(BGPv4)