Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 985

version 1 | 2c | 3 auth noauth priv community-string udp-port port-number notification-type (OPTIONAL) Enter the keyword version to specify the security model followed by the security model version number 1, 2c, or 3. • Version 1 is the least secure version • version 3 is the most secure of the security modes. • Version 2c allows transmission of informs and counter 64, which allows for integers twice the width of what is normally allowed. Default: Version 1 (OPTIONAL) Enter the keyword auth to specify authentication of a packet without encryption. (OPTIONAL) Enter the keyword noauth to specify no authentication of a packet. (OPTIONAL) Enter the keyword priv to specify both authentication and then scrambling of the packet. Enter a text string (up to 20 characters long) as the name of the SNMP community. Note: For version 1 and version 2c security models, this string represents the name of the SNMP community. The string can be set using this command, however it is recommended that you set the community string using the snmp-server community command before executing this command. For version 3 security model, this string is the USM user security name. (OPTIONAL) Enter the keywords udp-port followed by the port number of the remote host to use. Range: 0 to 65535. Default: 162 (OPTIONAL) Enter one of the following keywords as the type of trap to be sent to the host: • bgp - allow BGP state change traps • envmon - allows environment monitor traps • snmp - Allows SNMP-type notification (RFC 1157) traps. • stp - Allow Spanning Tree protocol notification (RFC 1493) • xstp - Allow MSTP (802.1s), RSTP (802.1w), and PVST+ state change traps Default: All trap types are sent to host Defaults As shown Command Modes CONFIGURATION Command History Version 8.3.5.0 Introduced on S55 Version 7.6.1.0 Support added for S-Series; Added support for STP and xSTP notification types. Version 7.5.1.0 Support added for C-Series E-Series legacy command Usage Information In order to configure the router to send SNMP notifications, you must enter at least one snmp-server host command. If you enter the command with no keywords, all trap types are enabled for the host. If you do not enter an snmp-server host command, no notifications are sent. In order to enable multiple hosts, you must issue a separate snmp-server host command for each host. You can specify multiple notification types in the command for each host. SNMP and Syslog | 985