Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 73

Usage Information The chassis MIB contain the entry chSysXfpRecvPower in the chSysPortTable table. Periodically, IFA polls the XFP power for each of the ports, and sends the values to IFM where it is cached. The default interval for the polling is 300 seconds (5 minutes). Use this command to enable the polling and to configure the polling frequency. end c e s Return to the EXEC Privilege mode from other command modes (for example, the CONFIGURATION or ROUTER OSPF modes). Syntax end Command Modes CONFIGURATION, SPANNING TREE, MULTIPLE SPANNING TREE, LINE, INTERFACE, TRACE-LIST, VRRP, ACCESS-LIST, PREFIX-LIST, AS-PATH ACL, COMMUNITY-LIST, ROUTER OSPF, ROUTER RIP, ROUTER ISIS, ROUTER BGP Command History Version 8.3.5.0 Introduced on the S55. Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command Related Commands exit Return to the lower command mode. epoch e Set the epoch scheduling time for the chassis. Syntax epoch {2.4 |3.2 | 10.4} To return to the default setting, enter no epoch. Parameters 2.4 3.2 10.4 Enter the keyword 2.4 to set the epoch to 2.4 micro-seconds and lower the latency. This option is available on the E600i and E1200i E-Series ExaScale systems only. Enter the keyword 3.2 to set the epoch to 3.2 micro-seconds and lower the latency. This option is available on the E600/E600i and E1200/E1200i only. ExaScale does not supports this setting with FTOS 8.3.1.0 and later. Enter the keyword 10.4 to set the epoch to 10.4 micro-seconds. This is the default setting and is available on the E300, E600/E600i, and E1200. Defaults 10.4 Command Modes CONFIGURATION Command History Version 8.3.1.0 Version 8.1.1.2 Added 2.4 micro-seconds option. ExaScale supports only 10.4 microseconds and 2.4 microseconds with FTOS 8.3.1.0 and later. Introduced on E-Series ExaScale E600i Control and Monitoring | 73