Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 450

www.dell.com | support.dell.com disable-on-sfm-failure e Disable select ports on E300 systems when a single SFM is available. Syntax disable-on-sfm-failure To delete a description, enter no disable-on-sfm-failure. Defaults Port is not disabled Command Modes INTERFACE Command History Version 7.7.1.0 Introduced on E300 systems only Usage Information When an E300 system boots up and a single SFM is active this configuration, any ports configured with this feature will be shut down. If an SFM fails (or is removed) in an E300 system with two SFM, ports configured with this feature will be shut down. All other ports are treated normally. When a second SFM is installed or replaced, all ports are booted up and treated as normally. This feature does not take affect until a single SFM is active in the E300 system. duplex (Management) c e Set the mode of the Management interface. Syntax duplex {half | full} To return to the default setting, enter no duplex. Parameters half Enter the keyword half to set the Management interface to transmit only in one direction. full Enter the keyword full to set the Management interface to transmit in both directions. Defaults Not configured Command Modes INTERFACE Command History Version 8.1.1.0 Version 7.5.1.0 Version 6.4.1.0 Introduced on E-Series ExaScale Introduced on C-Series Documentation modified-added Management to distinguish from duplex (10/100 Interfaces) Usage This command applies only to the Management interface on the RPMs. Information Related Commands interface ManagementEthernet duplex (Management) management route speed (Management interface) Configure the Management port on the system (either the Primary or Standby RPM). Set the mode of the Management interface. Configure a static route that points to the Management interface or a forwarding router. Set the speed on the Management interface. 450 | Interfaces