Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 85

motd-banner c e s Enable a Message of the Day (MOTD) banner to appear when you log in to the system. Syntax motd-banner To disable the MOTD banner, enter no motd-banner. Defaults Enabled on all lines. Command Modes LINE Command History Version 8.3.5.0 Introduced on the S55. Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command ping c e s Syntax Parameter Test connectivity between the system and another device by sending echo requests and waiting for replies. ping [vrf ] [host | ip-address | ipv6-address] [count {number | continuous}] [datagram-size] [timeout] [source (ip src-ipv4-address) | interface] [tos] [df-bit (y|n)] [validate-reply(y|n)] [pattern pattern] [sweep-min-size] [sweep-max-size] [sweep-interval] [ointerface (ip src-ipv4-address) | interface] vrf host ip-address ipv6-address count datagram size timeout (OPTIONAL) E-Series Only: Enter the VRF Instance name of the device to which you are testing connectivity. (OPTIONAL) Enter the host name of the devices to which you are testing connectivity. (OPTIONAL) Enter the IPv4 address of the device to which you are testing connectivity. The address must be in the dotted decimal format. (OPTIONAL) E-Series only Enter the IPv6 address, in the x:x:x:x::x format, to which you are testing connectivity. Note: The :: notation specifies successive hexadecimal fields of zeros Enter the number of echo packets to be sent. number: 1- 2147483647 Continuous: transmit echo request continuously Default: 5 Enter the ICMP datagram size. Range: 36 - 15360 bytes Default: 100 Enter the interval to wait for an echo reply before timing out. Range: 0 -3600 seconds Default: 2 seconds Control and Monitoring | 85