Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 416

www.dell.com | support.dell.com Parameters hello-interval milliseconds dead-interval milliseconds Enter the keyword hello-interval followed by the time, in milliseconds, to set the hello interval of the control packets. The milliseconds must be enter in increments of 50 milliseconds, for example 50, 100, 150 and so on. If an invalid value is enter, an error message is generated. Range: 50 to 2000ms Default: 500 ms Enter the keyword dead-interval followed by the time, in milliseconds, to set the dead interval of the control packets. Range: 50 to 6000ms Default: 1500ms Note: The configured dead interval should be at least three times the hello interval Defaults Default as shown Command Modes CONFIGURATION (conf-frrp) Command History Version 8.3.5.0 Version 8.2.1.0 Version 7.4.1.0 Introduced on the S55. Introduced for the C-Series Introduced Usage The hello interval is the interval at which ring frames are generated from the primary interface of the Information master node. The dead interval is the time that elapses before a timeout occurs. 416 | Dell Force10 Resilient Ring Protocol (FRRP)