Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 784
Command Example: Configuring a Port Monitor Source, Parameters, Defaults, Command Modes
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 784 highlights
www.dell.com | support.dell.com Parameters interface destination direction {rx | tx | both} Enter the one of the following keywords and slot/port information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/port information. Enter the keyword destination to indicate the interface destination. Enter the keyword direction followed by one of the packet directional indicators. rx: to monitor receiving packets only tx: to monitor transmitting packets only both: to monitor both transmitting and receiving packets Defaults No default behavior or values Command Modes MONITOR SESSION (conf-mon-sess-session-ID) Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.7.1.0 Version 7.5.1.0 Version 7.4.1.0 Introduced on S55 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced on E-Series Example Figure 29-3. Command Example: Configuring a Port Monitor Source Force10(conf-mon-sess-11)#source gi 10/0 destination gi 10/47 direction rx Force10(conf-mon-sess-11)# Usage Information Note: A SONET port can only be configured as a monitored port. 784 | Port Monitoring