Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 755

Table 26-13. Error Definitions: show ip ospf statistics process-id global Error Type Q-overflow Unknown-Pkt Description Packet(s) dropped due to queue overflow Received packet is not an OSPF packet Example The show ip ospf process-id statistics command displays the error packet count received on each interface as: • The hello-timer remaining value for each interface • The wait-timer remaining value for each interface • The grace-timer remaining value for each interface • The packet count received and transmitted for each neighbor • Dead timer remaining value for each neighbor • Transmit timer remaining value for each neighbor • The LSU Q length and its highest mark for each neighbor • The LSR Q length and its highest mark for each neighbor Figure 26-18. Command Example: show ip ospf process-id statistics Force10#show ip ospf 100 statistics Interface GigabitEthernet 0/8 Hello-Timer 9, Wait-Timer 0, Grace-Timer 0 Error packets (Only for RX) Intf-Down Wrong-Len Auth-Error Version SeqNo-Err 0 Non-Dr 0 Invld-Nbr 0 MD5-Error 0 AreaMisMatch 0 Unkown-Pkt 0 Self-Org 0 0 Nbr-State 0 0 Cksum-Err 0 0 Conf-Issue 0 0 Neighbor ID 9.1.1.2 Hello DDiscr LSReq LSUpd LSAck RX 59 3 1 1 1 TX 62 2 1 0 0 Dead-Timer 37, Transmit-Timer 0 LSU-Q-Len 0, LSU-Q-Wmark 0 LSR-Q-Len 0, LSR-Q-Wmark 1 Related Commands clear ip ospf statistics Clear the packet statistics in all interfaces and neighbors show ip ospf topology c e s Display routers in directly connected areas. Syntax show ip ospf process-id topology Parameters process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Defaults No default values or behavior Open Shortest Path First (OSPFv2 and OSPFv3) | 755