Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 1034
show config, show spanning-tree 0, protocol spanning-tree Command Example
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1034 highlights
www.dell.com | support.dell.com Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 7.7.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Example Figure 42-1. protocol spanning-tree Command Example Force10(conf)#protocol spanning-tree 0 Force10(config-stp)# Usage Information Related Commands STP is not enabled when you enter the SPANNING TREE mode. To enable STP globally on the switch, enter no disable from the SPANNING TREE mode. disable Disable Spanning Tree group 0. To enable Spanning Tree group 0, enter no disable. show config c e s Display the current configuration for the mode. Only non-default values are displayed. Syntax show config Command Modes SPANNING TREE Command History Version 8.3.5.0 Version 7.7.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Example Figure 42-2. show config Command for the SPANNING TREE Mode Force10(config-stp)#show config protocol spanning-tree 0 no disable Force10(config-stp)# show spanning-tree 0 c e s Display the Spanning Tree group configuration and status of interfaces in the Spanning Tree group. Syntax show spanning-tree 0 [active | brief | interface interface | root | summary] Parameters 0 active Enter 0 (zero) to display information about that specific Spanning Tree group. (OPTIONAL) Enter the keyword active to display only active interfaces in Spanning Tree group 0. 1034 | Spanning Tree Protocol (STP)