Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 871

Parameters prefix-list-name interface connected isis ospf static Defaults Not configured. Command Modes ROUTER RIP Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Related Commands ip prefix-list Enter the name of a configured prefix list. (OPTIONAL) Identifies the interface type slot/port as one of the following: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel, enter the keyword port-channel followed by a number from 1 to 32 for EtherScale, 1 to 255 for TeraScale, 1-128 on C-Series and S-Series. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. (OPTIONAL) Enter the keyword connected to filter only directly connected routes. (OPTIONAL) Enter the keyword isis to filter only IS-IS routes. Note: This option is only available on E-Series. (OPTIONAL) Enter the keyword ospf to filter all OSPF routes. (OPTIONAL) Enter the keyword static to filter manually configured routes. Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Enter the PREFIX-LIST mode and configure a prefix list. ip poison-reverse c e s Set the prefix of the RIP routing updates to the RIP infinity value. Syntax ip poison-reverse To disable poison reverse, enter no ip poison-reverse. Defaults Disabled. Command Modes INTERFACE Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Router Information Protocol (RIP) | 871