Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 960

www.dell.com | support.dell.com debug protocol-tunnel c e s Enable debugging to ensure incoming packets are received and rewritten to a new MAC address. Syntax debug protocol-tunnel interface {in | out | both} [vlan vlan-id] [count value] To disable debugging, use the no debug protocol-tunnel interface {in | out | both} [vlan vlan-id] [count value] command. Parameters interface in | out | both vlan vlan-id count value Enter one of the following interfaces and slot/port information: • For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Port Channel interface types, enter the keyword port-channel followed by a number from 1 to 255 for TeraScale and ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Enter the keyword in, out, or both to debug incoming interfaces, outgoing interfaces, or both incoming and outgoing interfaces. Enter the keyword vlan followed by the VLAN ID. Range: 1 to 4094 Enter the keyword count followed by the number of debug outputs. Range: 1 to 100 Defaults Debug Disabled Command Modes EXEC Privilege Command History Version 8.3.5.0 Version 8.2.1.0 Version 7.4.1.0 Introduced on S55 Introduced on the C-Series, E-Series and E-Series ExaScale. Introduced protocol-tunnel c e s Enable protocol tunneling per VLAN-Stack VLAN. Syntax protocol-tunnel stp To disable protocol tunneling, use the no protocol-tunnel stp command. Parameters stp Enter the keyword stp to enable protocol tunneling on a spanning tree, including STP, MSTP, RSTP, and PVST. Defaults No default values or behavior Command Modes CONF-IF-VLAN 960 | Service Provider Bridging