Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 629

Example Figure 21-2. show mac-address-table Command Output Example Force10#show mac-address-table VlanId Mac Address Type Interface 4094 00:00:a0:00:00:00 Dynamic Gi 2/0 State Active output truncated Example Figure 21-3. show cam mac linecard Command Output Example Force10#show cam mac linecard 2 port-set 0 VlanId Mac Address Region Interface 0 ff:ff:ff:ff:ff:ff STATIC 00001 4094 00:00:a0:00:00:00 DYNAMIC Gi 2/0 output truncated show cam mac linecard (dynamic or static) c e Display the CAM size and the portions allocated for MAC addresses and for MAC ACLs. Syntax show cam mac linecard slot port-set port-pipe [address mac_addr | dynamic | interface interface | static | vlan vlan-id] Parameters linecard slot port-set port-pipe address mac-addr dynamic interface interface static vlan vlan-id (REQUIRED) Enter the keyword linecard followed by a slot number to select the linecard for which to gather information. C-Series Range: 0 to 4 (C150); 0 to 8 (C300) E-Series Range: 0 to 6 (REQUIRED) Enter the keyword port-set followed by a Port-Pipe number to select the Port-Pipe for which to gather information. Range: 0 or 1 (OPTIONAL) Enter the keyword address followed by a MAC address in the nn:nn:nn:nn:nn:nn format to display information on that MAC address. (OPTIONAL) Enter the keyword dynamic to display only those MAC addresses learned dynamically by the switch. (OPTIONAL) Enter the keyword interface followed by the interface type, slot and port information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series Range: 1-128 E-Series Range: 1 to 255 for TeraScale. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. (OPTIONAL) Enter the keyword static to display only those MAC address specifically configured on the switch. (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to display the MAC address assigned to the VLAN. Range: 1 to 4094. Layer 2 | 629