Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 369
ip extcommunity-list, match extcommunity, Command Example
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 369 highlights
Command Modes Command History CONFIGURATION (conf-ext-community-list) Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced on S-Series Introduced on C-Series Introduced on E-Series ip extcommunity-list c e s Use this feature to enter the Extended Community-list mode. Syntax ip extcommunity-list word To exit from this mode, use the exit command. Parameters word Enter a community list name (maximum 16 characters). Defaults No defaults values or behavior Command Modes CONFIGURATION (conf-ext-community-list) Usage This new mode will change the prompt. See the example below. Information Example Figure 8-31. Command Example: ip extcommunity-list Force10(conf)#ip extcommunity-list test Force10(conf-ext-community-list)# Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced on S-Series Introduced on C-Series Introduced on E-Series match extcommunity c e s Use this feature to match an extended community in the Route Map mode. Syntax match extcommunity {extended community list name} To change the match, use the no match extcommunity {extended community list name} command. Parameters extended community list name Enter the name of the extended community list. Defaults No defaults values or behavior Command Modes ROUTE MAP (config-route-map) Usage Like standard communities, extended communities can be used in route-map to match the attribute. Information Border Gateway Protocol IPv4(BGPv4) | 369