Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 688

www.dell.com | support.dell.com clear ipv6 mroute e Clear learned multicast routes on the multicast forwarding table. To clear the PIM tib, use clear ip pim tib command. Syntax clear ipv6 mroute {group-address [source-address] | *} Parameters group-address [source-address] * Enter multicast group address and source address (if desired) to clear information on a specific group. Enter the addresses in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zero. Enter * to clear all multicast routes. Defaults No default behavior or values Command Modes EXEC Privilege Command History Version 7.4.1.0 Introduced ipv6 multicast-limit e Limit the number of multicast entries on the system. Syntax ipv6 multicast-limit limit Parameters limit Enter the desired maximum number of multicast entries on the system. Range: 1 to 50000 Default: 15000 Defaults Command Modes Command History Usage Information 15000 routes CONFIGURATION Version 8.3.1.0 Introduced The maximum number of multicast entries allowed on each line card is determined by the CAM profile. Multicast routes are stored in the IN-V6-McastFib CAM region, which has a fixed number of entries. Any limit configured via the CLI is superseded by this hardware limit. The opposite is also true; the CAM might not be exhausted at the time the CLI-configured route limit is reached. ipv6 multicast-routing e Enable IPv6 multicast forwarding. Syntax ipv6 multicast-routing To disable multicast forwarding, enter no ipv6 multicast-routing. Defaults Disabled 688 | Multicast