Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 383
cam-acl-egress, cam-optimization
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 383 highlights
Usage You must save the new CAM settings to the startup-config (write-mem or copy run start) then reload Information the system for the new settings to take effect. The total amount of space allowed is 16 FP Blocks. System flow requires 3 blocks and these cannot be reallocated. When configuring space for IPv6 ACLs, the total number of Blocks must equal 13. Ranges for the CAM profiles are 1-10, except for the ipv6acl profile which is 0-10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10). cam-acl-egress Allocate CAM for egress ACLs Syntax cam-acl-egress default | l2acl Parameters default l2acl number Reset egress CAM ACL entries to default settings. Allocate space for Layer 2 egress ACL. Range: 1-4 FP blocks Command Modes CONFIGURATION Command History Version 8.3.5.0 Introduced on the S55. cam-optimization c s Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space. Syntax cam-optimization [qos] Parameters qos Optimize CAM usage for Quality of Service (QoS) Command Modes Defaults CONFIGURATION Disabled Command History Version 8.3.5.0 Version 8.2.1.0 Version 7.8.1.0 Introduced on the S55. Introduced on the s-Series Introduced on the C-Series and S-Series Usage Information When this command is enabled, if a Policy Map containing classification rules (ACL and/or dscp/ ip-precedence rules) is applied to more than one physical interface on the same port pipe, only a single copy of the policy will be written (only 1 FP entry will be used). Note that an ACL itself may still require more that a single FP entry, regardless of the number of interfaces. Refer to IP Access Control Lists, Prefix Lists, and Route-map in the FTOS Configuration Guide for complete discussion. Content Addressable Memory (CAM) | 383