Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 766

www.dell.com | support.dell.com Parameters address group-address group-address mask override Enter the RP address in dotted decimal format (A.B.C.D). Enter the keyword group-address followed by a group-address mask, in dotted decimal format (/xx), to assign that group address to the RP. Enter the keyword override to override the BSR updates with static RP. The override will take effect immediately during enable/disable. Note: This option is applicable to multicast group range. Defaults Not configured Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.8.1.0 pre-Version 6.1.1.1 Introduced on S55 Introduced on E-Series ExaScale Introduced on S-Series Introduced on E-Series Usage Information This address is used by first-hop routers to send Register packets on behalf of source multicast hosts. The RP addresses are stored in the order in which they are entered. RP addresses learned via BSR take priority over static RP addresses. Without the override option, RPs advertised by the BSR updates take precedence over the statically configured RPs. ip pim rp-candidate c e s Configure a PIM router to send out a Candidate-RP-Advertisement message to the Bootstrap (BS) router or define group prefixes that are defined with the RP address to PIM BSR. Syntax ip pim rp-candidate {interface [priority] To return to the default value, enter no ip pim rp-candidate {interface [priority] command. Parameters interface priority Enter the following keywords and slot/port or number information: • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For Port Channel interface types, enter the keyword port-channel followed by a number from 1 to 255. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. (OPTIONAL) Enter the priority used in Bootstrap election process. Range: zero (0) to 255 Default: 192 Defaults Not configured. Command Modes CONFIGURATION 766 | PIM-Sparse Mode (PIM-SM)